Precautions for installing solar panels and structural diagram for using butyl tape

When sealing the solar panel, please note that the original tape on the solar panel is only used for temporary protection of the edge of the panel and is not resistant to aging. During installation, cut the panel according to the size, and after cutting, use butyl tape to seal the end hole grid of the panel according to the installation regulations, and replace the original tape. The installation engineering special tape should have good weather resistance, and long-term use should not lose its adhesion and mechanical strength.

When installing tape, pay attention to the following points

(1) Ensure that the edges of the board are smooth.

(2) To blow all holes clean, the compressed air must be free of any impurities and dry.

(3) Ensure that the tape is completely covered with profiles, metal cover plates, and U-shaped protective grooves at the ends. After installation, there should be no exposed parts.

(4) Before pre installation and final installation, check for any loss of tape. If any damaged tape is found, it must be replaced

Cleaning methods for solar panels

(1) When cleaning, rinse with warm water below 60 ℃.

(2) Neutral detergent should be used during cleaning, and it is not allowed to use detergents that have a corrosive effect on the sun panel.

(3) Please use a soft cloth or sponge dipped in neutral solution to gently scrub. Do not use coarse cloths, brushes, mops, or other hard, sharp tools for cleaning.

(4) When there is grease, wet paint, tape marks, etc. on the surface, a soft cloth with alcohol can be used to scrub.

(5) Clean the dirt thoroughly with clean water.

(6) Finally, use a clean cloth to dry and polish the board surface, and there should be no obvious water stains.

The above are the installation precautions for the solar panel. When installing the solar panel, everyone should pay more attention and not damage it.